Cisco PIX Series User And Installation Manual page 63

Chapter 4 PIX 515/515E
Insert a circuit board through the cage opening and into the slot as shown in
Step 3
Figure 4-21 Inserting a Circuit Board into the PIX 515/515E
Note
Attach the back cover plate making sure that the connecting flange on the circuit board goes through the
Step 4
slot on the back cover plate as shown in
Figure 4-22 Attaching PIX 515/515E Back Cover Plate
Attach the screw to hold the circuit board connecting flange to the cover plate, and install the screws to
Step 5
attach the cover plate to the PIX 515/515E.
Reattach the chassis cover.
Step 6
78-15170-03
When you insert a four-port Ethernet circuit board in the slot, the end of the circuit board
connector extends past the end of the slot. This does not affect the use or operation of the circuit
board.
Installing a Circuit Board in the PIX 515/515E
Figure 4-22.
Cisco PIX Security Appliance Hardware Installation Guide
Figure 4-21.
4-21