Installing A Circuit Board In The Pix 525 - Cisco PIX Series User And Installation Manual

Chapter 6 PIX 525

Installing a Circuit Board in the PIX 525

This section includes the following topics:
•
•
•
The PIX 525 Restricted Interface Options can have a maximum of six interfaces, and for the Unrestricted
Note
Interface Options, a maximum of eight interfaces.
Table 6-3
restricted and unrestricted interface options.
Table 6-3
Restricted Interface Options
3 FE
2 FE + 1 VPN Accelerator
3 GE
2 GE + 1 VPN Accelerator
1 GE + 1 FE
1 GE + 1 FE + 1 VPN Accelerator
1 4-Port FE
1 4-Port FE + 1 VPN Accelerator
2 4-port FE
To install a circuit board in the PIX 525, perform the following steps:
Locate the grounding strap from the accessory kit. Fasten the grounding strap to your wrist so that it
Step 1
contacts your bare skin. Attach the other end to bare metal on the PIX 525 chassis.
Step 2 Remove the screws from the rear panel of the component tray and slide the tray out (see
78-15170-03
Fast Ethernet Circuit Board, page 6-17
VPN Accelerator Circuit Board, page 6-18
Gigabit Ethernet Circuit Board, page 6-18
lists the possible options/examples of configuration choices available for the PIX 525
PIX 525 Interface Options
Unrestricted Interface Options
3 FE
2 FE + 1 VPN Accelerator
3 GE
2 GE + 1 VPN Accelerator
1 GE + 2 FE
1 GE + 1 FE + 1 VPN Accelerator
1 4-port FE
1 4-port FE + 2 FE
2 4-port FE
1 4-port FE + 2 GE
1 4-port FE + 1 VPN Accelerator
1 4-port FE + 1 VPN Accelerator + 1 FE
1 4-port FE + 1 VPN Accelerator + 1 GE
Cisco PIX Security Appliance Hardware Installation Guide
Installing a Circuit Board in the PIX 525
Figure 6-14).
6-15