Installing A Circuit Board - Cisco PIX Series User And Installation Manual

Chapter 7 PIX 535

Installing a Circuit Board

Note It is not necessary to remove the chassis cover on the PIX 535 to install or replace a circuit board. A
component tray, that slides out from the rear panel, contains slots for installing circuit boards and
memory boards.
To install a circuit board in the PIX 535, perform the following steps:
Locate the grounding strap from the accessory kit. Fasten the grounding strap to your wrist so that it
Step 1
contacts your bare skin. Attach the other end to bare metal on the PIX 535 chassis.
Figure 7-11 The Component Tray at the Back of the PIX 535
Loosen the attachment screws from the rear panel of the component tray and slide the tray out.
Step 2
Select a slot for the circuit board and remove the screw and slot cover plate from the back panel on the
Step 3
component tray.
Install the circuit board into the slot. The front plate on the circuit board should be against the slot
Step 4
opening on the component tray back panel.
Use the screw that was removed in
Step 5
rear panel.
Step 6 Reinstall the component tray and tighten the attachment screws.
78-15170-03
STATUS
STATUS
Step 3 to attach the circuit board front plate to the component tray
Cisco PIX Security Appliance Hardware Installation Guide
Installing a Circuit Board in the PIX 535
7-17