Cisco PIX Series User And Installation Manual page 143

Chapter 7 PIX 535
Reconnect power to the PIX 535. After wiring the DC power supply, remove the tape from the circuit
Step 9
breaker switch handle and reinstate power by moving the handle of the circuit breaker to the ON position.
If needed, install the interface boards as described in the
Step 10
section on page
Power on the unit from the switch at the rear of the unit.
Step 11
Note If you need to power cycle the DC PIX 535, wait at least 5 seconds between powering off the unit and
powering it back on.
Your unit is now ready to configure. Refer to the
http://www.cisco.com/en/US/products/sw/secursw/ps2120/prod_configuration_guides_list.html.
78-15170-03
7-14.
"Installing a Circuit Board in the PIX 535"
configuration guide online
Cisco PIX Security Appliance Hardware Installation Guide
Installing the PIX 535 DC Model
at:
7-23