Pix 525 Feature Licenses - Cisco PIX Series User And Installation Manual

Chapter 6 PIX 525
Connect the network cables to the expansion interface ports. (The inside, outside, or perimeter network
Step 6
connections can be made to any available interface port on the PIX 525.) The first expansion port
number, at the top left, is interface 2. Starting from that port and going from left to right and top to
bottom, the next port is interface 3, the next is interface 4, and so on. Refer to the
Licenses" section on page 6-5
If you have a second PIX security appliance to use as a failover unit, install the failover feature and cable
Step 7
as described in the
Note
When you are ready to start the PIX 525, power on the unit from the switch at the rear of the unit.
Step 8

PIX 525 Feature Licenses

If you have the PIX-525-UR unrestricted feature license, the following options are available:
•
•
•
•
For information on upgrading feature licenses or downloading the latest software versions, refer to the
configuration guide
http://www.cisco.com/en/US/products/sw/secursw/ps2120/prod_configuration_guides_list.html
This section includes the following topics:
•
•
78-15170-03
"Installing Failover" section on page
Do not power on the standby failover unit until the primary unit is configured.
If you have a second PIX 525 to use as a failover unit, install the failover feature and cable as
described in the "Installing Failover" section on page
If needed, install the PIX security appliance syslog server as described on the logging command
page in the command reference
http://cisco.com/en/US/products/sw/secursw/ps2120/prod_command_reference_list.html
If you need to install an optional circuit board, refer to the
PIX 525" section on page
If you need to install additional memory, refer to the
page 6-12.
online at:
VPN Accelerator Card, page 6-6
VPN Accelerator Card+, page 6-6
for information on how to configure the ports.
online at:
6-15.
Cisco PIX Security Appliance Hardware Installation Guide
PIX 525 Feature Licenses
"PIX 525 Feature
6-6.
6-6.
"Installing a Circuit Board in the
"Installing a Memory Upgrade" section on
6-5