SP600 installation and user's guide
www.renishaw.com
Probe installation
SP600 probe
The shank mounted SP600 attaches simply and quickly to any CMM providing that the correct shank attachment has been ordered as
shown below. The shank is inserted into a mechanical fixing mechanism and tightened into place, with the Renishaw emblem facing the
front of the CMM. The probe cable should then be connected to the external hirose connector on the side of the SP600.
SP600M probe
The SP600M probe may be mounted on either the PH10M PLUS / PH10MQ PLUS range of motorised probe head or the PH6M fixed
probe head by means of the Renishaw autojoint. Locking and unlocking of the autojoint is carried out either manually, using the autojoint
key, as shown below, or automatically using the Renishaw autochange rack system. In both cases, the connection repeatability eliminates
the need for probe requalification after exchange.
1. Align the black dot on the probe with the black dot on the head.
2. Locate the two halves of the joint together.
3. Insert the S10 key in the slot.
4. Turn the key clockwise until it locks tight.
Issued 01 2018
18