SP600 installation and user's guide
www.renishaw.com
System connection
The SP600 probe connects to the AC2 via the PH10M PLUS or PH6M head and standard multiwire cables. This cable connects directly
to the PH10M PLUS or PH6M head via a micro 'D' and terminates in a 15-way high-density 'D' which connects directly to the rear panel of
the AC2 card.
System connections are as shown in the following illustrations. Ensure all cables are screwed firmly into their sockets. For further
information on cables see
'SP600
SP600Q with AC2
Overtravel unit
As the overtravel unit cannot be used, one of the following is required:
Ignore the overtravel bit of the AC2 status byte
Link pins 17 and 18 of the 26-way high density D connector.
SP600M and PH6M with AC2
Overtravel unit
As the overtravel unit cannot be used, one of the following is required:
Ignore the overtravel bit of the AC2 status byte
Link pins 17 and 18 of the 26-way high density D connector.
Issued 01 2018
cables'.
33