Channels Without Delay; Timers (General) - GRAUPNER mc-28 Programming Manual

Channels without delay

Annnounce
Phase settings
Phase assignment
Phase trim
Non-delayed chan

Timers (general)

Non-delayed channels
non-delay
normal
7 8 9 10 11 12
Normal
Timers (general)
Non-delayed chan
Timers (general)
Phase timers
Wing mixers
Free mixers
MIX active/phase
Model time 12:34h
Batt. time 1:23h
Top: Stop
Centr : Log t.
Timer
33028_mc_28_Teil2_jh
Note
The trim of "Elevator", "Aileron" and "Rudder" is factory-set to
"Global". This setting can be changed at any time to "phase-specific"
in the "Sticks setting" menu.
In this menu, you can switch off the switching delay set in the "Phase
setting" menu for individual control channels that are dependent on
the phase.
• Switch to the corresponding phase (this is shown in the lower left
corner of the display).
• Set the desired channel through the selection keys.
• Use the SET button to change the channel (normal / reverse)
The model timer, battery timer, Timer up and Timer middle are set
here.
Model time
This timer shows the currently recorded used time of the active
model memory. To switch the time recording manually, assign a
switch in the right column.
–––
The buttons
t u
0:00
to "0:00h".
0:00
Batt time
This timer shows the use time of the battery. The timer will be reset
as soon as the battery is fully charged. The time is added at each use
of the transmitter.
The buttons
t u
to "0:00h".
Timer up and middle
These two timers are located in the upper right half of the basic dis-
play. A different name can be assigned. The function and use mode
depend on the name. Regardless of the name, the "up" and "middle"
timer can be programmed backwards or forwards as a "timer".
Stop/motor
These two timers will start and stop with a switch, in the column "
". Move the marking frame with the selection key  over the
"Timer" column to the right side to reach the column.
or  of the right touch-pad reset the timer
or  of the right touch-pad reset the timer
39 / 80