Phase Setting - GRAUPNER mc-28 Programming Manual

Announce
GL
1 –––
2 ––– GL
3 ––– GL
4 ––– GL
Typ

Phase setting

Announce
Phase settings
Phase assignment
Phase trim
Non-delayed chan
Timers (general)
Pha1 nor mal

Pha2 –
Pha3 – Strecke
Pha4 –
Pha5 –
Name ph.Tim.
Pha1 Normal 0.1s

Pha2 + Star t 0.1s
Pha3 + Track 0.1s
Pha4 – 0.1s
– 0.1s
Pha5
Name Sw.time
Pha1 nor mal

Pha2 – Star t
Pha3 – Strecke
Pha4 –
Pha5 –
Announce
GRAUBELE T 0:00.0
#01 P 0:00.0
Time1
«Speed »
3.9V 0:00.0
K78
2:22h M 5.5V
36 / 80
Assigning the switch / Selecting the announce
• In the column "
switch position
• In the column "Type" decide if the announces act globally (GL) or
according to the phase (PH)
• In the right column select the announces available in the mem-
ory
In this menu you can set up to seven different phases for the model
memory. Assign a name to the phases. The phase names are created
in the "General settings" menu. All the settings are dependent on
the selected phase. The state of the phase is displayed in the second
column:
Character Description
– No switch assigned
+ Phase recallable through switch
Indicates the actually active phase

Creating a phase
 Select the line of the desired phase
 Select the phase name
 Select an optional phase timer
 Set a switching timer
 Set an announce
Timer 1, Timer 2, Timer 3, Lap, Time1, Time2
There are additional timers displayed in the main display of the
transmitter. These timers can be set up in the "Phase timer" menu.
The phase timers "Timer 1 ... 3" and "Time1" and "Time2" are active
only in the phase assigned. In other phases they will be held and not
displayed. The assigned start/stop switch has no function. The lap
timer works even if a phase change is activated. The lap timer can be
00
stopped in each phase with the central ESC button.
With the "Lap" timer you can measure the lap time through a switch.
" assign a switch (or an announce) for each
33028_mc_28_Teil2_jh