Phase Assignation; Phase Trim - GRAUPNER mc-28 Programming Manual

Pha1 normal

Pha2 – Star t
Pha3 – Strecke
–
Pha4
Pha5 –
Announce

Phase assignation

Announce
Phase settings
Phase assignment

Phase trim

Non-delayed chan
Timers (general)
Phase assignment
prior combi
A B C D E
1 Normal
Phase assignment
prior combi
C D E
A B
2 6 5
1 Nor mal
Phase assignment
prior combi
A B C D E
2 6 5
2 Star t
Phase trim
Announce
Phase settings
Phase assignment
Phase trim
Non-delayed chan
Timers (general)
Nor mal 0%
Star t 0%

Ther mal 0%
Track 0%
Star t
ELEV AI
38 / 80
Announce
Here you can select an announce for each phase. The announce can
be selected from the supplied voice pack or from a user voice pack.
Switching to the corresponding phase reproduces the announce.
In this menu, you can assign a switch or switch combination to the
phases.
Priorities
If no phase switches have been assigned you are in phase "1". When
you start programming phases, this phase must be designed with
the phase name "Normal" in the "Phase settings" menu (described
above). The phase switch "A" has priority over all subsequent switch
F
positions "B" to "F". The phase switch "B" has priority over all subse-
quent switch positions "C" to "F", etc.
Assigning the switch
• Use the selection keys to select the desired position, then press
the SET button
F
• Move the desired switch
Assigning the phase and the switch position
• Use the selection keys to highlight the field at the bottom right
and tap the SET button
F
• Move the desired switch or switch combination
• Select the desired phase name
In this menu, enter the phase-dependent trim settings for the wing
controls. The available flaps that appear depend on the setting in the
"Model type" menu. (ELE, AILE, AILE2, FLAP, FLAP2)
Setting the trim values:
• Select the desired phase
• Select the desired control surfaces (additional control surfaces
0%
on the right are available if a triangle is shown at the bottom left)
0%
0%
• Tap on the SET button, input the trim value
0%
The values of these four columns are identical to those of the line
"FLAP Pos" (flap position) in the "Multi-flap menu" of the "Wing
mixer" menu. Changes always act directly on the other side of the
other menus.
33028_mc_28_Teil2_jh