Switch-On Melody; Battery Alarm Threshold; Switch-On Warning; Touch Sensitivity - GRAUPNER mc-28 Programming Manual

Switch-on melody

Battery alarm threshold

Switch-on warning

Touch sensitivity

DATA sel.

Ph. Name 1 ... 10

BT headset and following lines

Basic settings
BT Headset A2DP
BTH002
ID PAIR OK
BT Volume
SEL
33028_mc_28_Teil2_jh
In this line, you can turn on and off the switch-on and the switch-off
sounds.
In this line you can preset the warning threshold of the display in
0,01V steps between 3.50 and 4.50 V (depends on the type of bat-
tery used). Make sure that the set value is not too low to give you
sufficient time to land your model after a battery warning.
Here select the period until the switch-on warning becomes active
("unlimited" = off). If you do not operate an operating element within
the set time, an optical and acoustic warning is issued. If no operat-
ing element is run, the transmitter switches off after approximately
three minutes.
In this line you can set the touch sensitivity of the touch buttons in
the range from 1 to 10. The lower the number, the faster the reac-
tion.
A Smart Box, an external RF module or the external Bluetooth mod-
ule of the mz transmitters (No. 8351) can be operated on the data
socket. Following settings are possible:
"Telemetry"
Data protocol for an external RF module and for data output on the
Smart Box in the "EXTERNAL MONITOR" menu.
"BLUETOOTH"
Data log for the external Bluetooth module (No. 8351) and for trans-
mitting telemetry data and voice output on smartphones and tablets
with "Graupner HoTT Viewer App for Android".
Here you can input your own phase names. These names are dis-
played when you activate the phase.
You can assign up to seven characters per phase name.
Here you can find and pair Bluetooth devices. You can also select the
transfer method and deselect all connections to BT devices. When a
connection is established, the next line shows the number of paired
1/3
devices. In the next line you can start and stop an existing connec-
ON
8
tion. In the last line you can adjust the volume of the Bluetooth
device.
67 / 80