Model Type - GRAUPNER mc-28 Programming Manual

Model type

Suppress models
Base setup model
Model type
Ser vo adjustment
Stick mode.
Control adjust
M o d e l t y p e
Motor at C1 None
Leitwerk nor mal
Querr./Wölb
Bremsoffs. +100%
33028_mc_28_Teil2_jh
In this menu you can adjust the settings of the model type. For exam-
ple, you can select the tail and wing type or whether or not the
model has a motor.
in this menu only the line "Motor at CH1" will appear if you chose
copter, car or boat in the model selection. You have the following
selection possibilities:
1QR
Ein1
"None"
SEL
You are using a model without a motor. The warning "Throttle too
high!" is deactivated and the sub-menu "Brake settings" of the "Wing
mix" menu is available.
"Backward"
Sets the idle position of the Throttle/Airbrakes control stick (CH1) to
the backward position, in the pilot direction. The warning "Throttle
too high!" and the "Throttle cut" option of the "Model base settings"
menu are active.
"Forward"
Sets the idle position of the Throttle/Airbrakes control stick (CH1) to
the forward position, in the opposite direction of the pilot. The warn-
ing "Throttle too high!" and the "Throttle cut" option of the "Model
base settings" menu are active.
Note
Your selection of "normally" or "backward"/"forward" enacts the
CH1 trim through the entire control travel or in the related idle direc-
tion, respectively.
Please pay attention to the "Switch-off trim" function described in
the "Digital trim" section.
25 / 80