Switch Display; Control Switch - GRAUPNER mc-28 Programming Manual

Switch display

Channel 1 cur ve
Switch display

Control switch

Logical switch
Announce
Phase settings
Schalter
1 2 3 4
6 7 8 9
11 12 13 14
C 1 C 2 C 3 C 4
C 5 C 6 C 7 C 8
Control switch
Channel 1 cur ve
Switch display
Control switch
Logical switch
Announce
Phase settings
Control switch
C1 Gb1 0%
C2 Gb1 0%
C3 0%
C4 0%
SEL STO
SEL
Control switch
G1 Gb1 –75%
Move desired
G2 Gb1 +75%
control adj.
C3 0%
C4 0%
SEL STO SEL
Control switch
C1 SD2 +85%
C2 0%
C3 0%
C4 0%
SEL STO SEL
34 / 80
The switch display is a check function of the switches and control
switch in the transmitter.
Active switches are highlighted. On the right near the switch num-
ber, the switch position is displayed with a switch-symbol.
5
10
15
In this menu a switch function is paired to the control travel of a pro-
portional control.
Assigning the control switch:
• Select the line of the desired control switch
• Activate the column "SEL" with the SET button
• Operate the desired control and the abbreviation of the control
–––
–––
will appear
–––
–––
Deleting the control switch:
• Use the SET button to select the desired field
–––
–––
• Tap on the selection buttons "left/right" or "up/down" at the
–––
–––
same time
Setting the switching point
• Select the STO column
• Move the control to the desired position
• Save the position through the SET button
Setting the switch direction:
• Select the column SEL and change the switch direction with the
SET button
Combining the control switch
A control switch can be controlled by another switch. In specific sit-
10
uations the function can be switched, independently from the con-
–––
–––
trol position and from the control switch position. Assign a switch in
–––
the column "
control switch in the column "
". You can also combine 2 control switches. Select a
"
33028_mc_28_Teil2_jh