Info Display; Digital Trim / Throttle Switch-Off Trim (Function) - GRAUPNER mc-28 Programming Manual

Info display

RFID ABCDEF12
fir mware ver. 1.234
date 2016/09/17(Sa )
18:19:20s
time
SD-CARD 3896MB
available 3623MB

Digital trim / Throttle switch-off trim (function)

actual last idle position
trim position
C1 trim lever
GRAUBELE S 0:00
#01 L 0:00
5.2V
K78
2.4
3:33h M RX0.0V
Trimming in
Motor-OFF position
actual last idle position
trim position
Throttle limiter in start position
GRAUBELE S 0:00
#01 L 0:00
5.2V
K78
2.4
3:33h M RX0.0V
Trimming in
Motor-OFF position
Throttle limiter in release position
GRAUBELE S 0:00
#01 L 0:00
5.2V
K78
3:33h M RX0.0V
2.4
33028_mc_28_Teil2_jh
This menu shows information about the transmitter and the SD card.
The date and time can be set here.
RFID - Identity number of the transmitter
Firmware version - shows the version of the transmitter firmware
92%
Dat. - Date (also used for log files)
Time - Time (also used for log files)
SD card - shows the capacity of the inserted SD card
Available - shows the free space on the SD card
Percentage display - used space as % of the SD card
A special function is integrated in the digital throttle trim, enabling
the adjustment of the idle speed of an engine. This "switch-off trim"
is effective only in the range of -1 to -100% and only if front or rear is
entered in the "Motor type CH1" line in the "Model type" menu.
The throttle trim has a special "cut-off trim" intended for engines.
First set the motor to safe idle with the trim.
A further marking remains at the end position in the display if the
throttle trim is moved from this position to the end of the trim travel
in the "motor stop" direction.
Then simply push the trim once more in the "higher throttle" direc-
tion to reset the trim to the last idle setting.
With the model type "Heli", the throttle trim in combination with the
"throttle limit function" has a further property. The throttle trim acts
as an idle trim on the throttle servo if the throttle limit control is in
the range -1 to -100%. The indication of the idle trim is visible in the
display.
The position indicator
when the throttle limit control is in the range 0 to + 100%.
The throttle trim works only on the throttle, not on the pitch servos.
Note that the heli throttle servo must be connected to the output 6
of the receiver.
and a predefined idle position are dimmed
( )
69 / 80