SECTION 5:
MAINTENANCE
Applying Power
The Electronics Assembly and Battery Pack are mounted to an aluminum tray, which is attached to the
Release End Cap. Once the Transducer End Cap is removed, the battery can be plugged in.
1. Plug the 4-pin battery connector into the header JP5 on the circuit board. When doing so, ensure
to line the pins up correctly as shown in
Figure 4-9: Battery Connection Location and One Method for Plugging in the Board
Ensure the 4-pin battery pack cable connector alignment tabs are
properly aligned with the power connector on the electronics assembly
before pressing into place. If misaligned, damage to the electronics may
occur, rendering the Release unusable until repaired.
Figure 4-10: The Proper Orientation of the Battery Pin Connector and JP5
F
4-9
F
4-10.
and
IGURE
IGURE
CAUTION!
4-6