Table of Contents
Advertisement
If the pump is a Dionex ICS-3000 DP or ICS-3000 SP, go to the next
section to update the firmware.
If the pump is not a Dionex ICS-3000 DP or ICS-3000 SP, go to
configure the pump TTLs.
Download the New Dionex ICS-3000 DP/SP Firmware
1. On the General tab page in the Properties dialog box, click Install
Firmware. A message notifies you of the firmware version that is
currently installed in the pump and the version that will be
downloaded from the data system.
If firmware version 4.1.0 (or later) is already installed, click No to
cancel the download. Go directly to the next section to configure the
pump TTL inputs.
2. If the installed firmware version is earlier than version 4.1.0:
a. Click No to cancel the download.
Doc. 065355-04 05/18
Dionex SRD-10 Installation Instructions
page 8
to
7
Advertisement
Table of Contents
