Table of Contents
Advertisement
Dionex SRD-10 Installation Instructions
If the pump is a Dionex ICS-3000 DP or ICS-3000 SP, go to the next
section to update the firmware.
If the pump is not a Dionex ICS-3000 DP or ICS-3000 SP, go to
to configure the pump TTLs.
Download the New Dionex ICS-3000 DP/SP Firmware
1. On the General tab page in the Properties dialog box, click Install
2. If the installed firmware version is earlier than version 4.1.0:
10
Firmware. A message notifies you of the firmware version that is
currently installed in the pump and the version that will be
downloaded from the data system.
If firmware version 4.1.0 (or later) is already installed, click No to
cancel the download and go directly to the next section to configure
the pump TTL inputs.
a. Click No to cancel the download.
page 11
Doc. 065355-04 05/18
Advertisement
Table of Contents
