(12) Wind value setting for FAN (VACUUM)
Sets wind value for FAN.
#VACUUM
>01 : NORMAL
<Parameter (Enter a choice)>
-
NORMAL: Absorbs the paper at the normal wind value.
-
LOW:
(13) Wait of heating setting (WAIT HEATER)
Sets whether print should wait for time that the heater temperature
reaches the preset temperature.
#WAIT HEATER
>01 : WAIT
<Parameter (Enter a choice)>
- WAIT:
- SKIP:
(14) Initial temperature setting for the front heater (FRONT HEATER)
Sets the front heater temperature.
(Celsius)
#FRONT HEATER
>01 : 30C
<Parameter (Enter a value)>
-
Range:
Absorbs the paper at the low wind value.
Waits the time until the heater temperature reaches
the preset temperature.
Starts printing even if the heater temperature does
not reach the preset temperature.
(Fahrenheiht)
#FRONT HEATER
>01 : 086F
15 °C to 55 °C
(The heater will be OFF when "**" is set.)
Menu Operations
3-23