Chapter 6 Appendix; Regulatory Compliance And Flight Restricted Area; Compliance And Advisory - Autel Robotics EVO User Manual

Chapter 6
Appendix
6.1 Regulatory Compliance and Flight
Restricted Area

6.1.1 Compliance and Advisory

FCC Compliance
FCC Warning Message
"OZ DIBOHFT PS NPEJmDBUJPOT OPU FYQSFTTMZ BQQSPWFE CZ UIF QBSUZ SFTQPOTJCMF GPS DPNQMJBODF DPVME WPJE
the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
For EVO Series / EVO
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator&
your body. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
For EVO Series with model EF7, SAR tests are conducted using standard operating positions
accepted by the FCC/ISEDC with the device. when used, please keep the distance with a
minimum of 10mm from the body.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.