Pair The Aircraft And Remote Controller - Autel Robotics EVO User Manual

controller. You can calibrate your remote controller according to the following
VWHSV RU E\ XVLQJ WKH PRELOH DSS UHIHU WR WKH $SS 0DQXDO IRU PRUH LQIRUPDWLRQ
1.
Turn off the remote controller. Press
and hold the Power Button
and Take-off/Landing Button
simultaneously until
appears as shown on the right. The
four crossed bars represent the left
and right Command
horizontal bar at the top represents
the Gimbal Pitch Dial.
2.
Release both Command Sticks
the Gimbal Pitch Dial
central position. The three central
rounds on the RC calibration screen
will be highlighted successively.
3.
Push both Command Sticks
HQGV RI WKHLU  GLUHFWLRQV DQG WXUQ WKH
Gimbal Pitch Dial
FRXQWHUFORFNZLVH WR LWV  HQGV KROGLQJ
respectively until you hear a beep.
4.
All the bars on the screen will be
fully highlighted when calibration is
completed.

3.2.4 Pair the Aircraft and Remote Controller

The remote controller and aircraft are factory paired. However, when you change
an aircraft or remote controller, or activate the
you will need to pair your aircraft and remote controller again.
(
(
the screen
Sticks, and the
and
naturally to the
to the
clockwise and
RC Pairing Button

on the aircraft,