Vega VEGAPULS 62 Operating Instructions Manual page 14

3 Product description
VEGACONNECT
VEGADIS 81
VEGADIS adapter
Overvoltage protection
Flanges
Protective cover
Electronics module
Supplementary electron-
ics for Profibus PA
Antenna impedance cone
14
The interface adapter VEGACONNECT enables the connection of
communication-capable instruments to the USB interface of a PC. For
parameter adjustment of these instruments, the adjustment software
PACTware with VEGA-DTM is required.
You can find further information in the operating instructions "Interface
adapter VEGACONNECT" (Document-ID 32628).
The VEGADIS 81 is an external display and adjustment unit for VEGA
plics sensors.
®
For sensors with double chamber housing the interface adapter
"VEGADIS adapter" is also required for VEGADIS 81.
You can find further information in the operating instructions
"VEGADIS 81" (Document-ID 43814).
The VEGADIS adapter is an accessory part for sensors with double
chamber housings. It enables the connection of VEGADIS 81 to the
sensor housing via an M12 x 1 plug.
You can find further information in the supplementary instructions
"VEGADIS adapter" (Document-ID 45250).
The overvoltage arrester B81-35 is used in the single or double
chamber housing instead of the connection terminals. It reduces any
voltage surges that may reach the signal cables to a harmless level.
You can find further information in the supplementary instructions
"Overvoltage arrester B81-35" (Document-ID 50708).
Screwed flanges are available in different versions according to the
following standards: DIN 2501, EN 1092-1, BS 10, ASME B 16.5,
JIS B 2210-1984, GOST 12821-80.
You can find additional information in the supplementary instructions
manual "Flanges according to DIN-EN-ASME-JIS".
The protective cover protects the sensor housing against soiling and
intense heat from solar radiation.
You will find additional information in the supplementary instructions
manual "Protective cover" (Document-ID 34296).
Electronics module "VEGAPULS series 60" is a replacement part for
radar sensors of VEGAPULS series 60. A different version is available
for each type of signal output.
You can find further information in the operating instructions "Elec-
tronics module VEGAPULS series 60" (Document-ID 36801).
The supplementary electronics is a replacement part for sensors with
Profibus PA and double chamber housing.
You can find further information in the operating instructions "Supple-
mentary electronics for Profibus PA" (Document-ID 42767).
The antenna impedance cone is a replacement part used for optimum
transmission of microwaves and for sealing against the process.
VEGAPULS 62 • Profibus PA