Troubleshooting Chart - Standard Horizon HX890 Owner's Manual

1. The RESET screen is displayed on step 1 in "Checking
the Request code".
2. Press the [CH▼]/[CH▲] key to select "PASSWORD", then
press the [SELECT] soft key.
The password input screen will appear.
3. Input the acquired reset code.
• Select the character with the [CH▼]/[CH▲]/[◄]/[►] keys
• Press the [SELECT] soft key to input the character
• Press the [SELECT] soft key to select "←" or "→" on the
screen to move the cursor.
• Press the [SELECT] soft key to select "Delete" on the
screen to delete the selected character
4. Press the [FINISH] soft key.
If the reset is successful, "COMPLETE!" will appear on
the screen.
If the error message is displayed, input the reset code again.
5. Press the [OK] soft key to return to setup screen.
The acquired reset code is available only one time.

18.4 TROUBLESHOOTING CHART

SYMPTOM
The USA/INTL/CAN modes
do not function.
Cannot output sound by
pressing and holding the
[SQL] key.
Cannot transmit a DSC Call.
Cannot fix the GPS satellites.
Charge indicator does not
appear on the display
when charging a battery.
NOTE
PROBABLE CAUSE
Proper operation not
followed.
Low battery.
Audio volume level is too
low.
M M S I n u m b e r i s n o t
programmed.
Internal GPS receiver is
"off".
Poor location for GPS
satellite reception.
Defective battery SBR-13LI.
The transceiver is not set
onto the SBH-32 Charger
Cradle properly.
Power is not supplied to the
SBH-32 Charger Cradle.
REMEDY
Specify the item number from
"SETUP MENU" – "CH SETUP" –
"CH GROUP".
Charge battery. Refer to section 6
of this manual.
Press the [VOL+] key until back-
ground noise outputs.
Program the MMSI number. Refer
to section "6.4.2 Programming
the MMSI".
Internal GPS receiver is "on". Refer
to "16.1 GPS ON/OFF".
Move to a less obstructed position.
Contact Standard Horizon dealer.
Set the transceiver onto the SBH-32
Charger Cradle properly.
Connect SAD-25 or E-DC-19A to
the SBH-32 Charger Cradle for AC/
DC power supplies.
CONFIGURATION
USER MMSI RESET
REQUEST CODE
PASSWORD
BACK SELECT
CONFIGURATION
PASSWORD INPUT
-
----- -----
A B C D E F G H I J K L M
N O P Q R S T U V W X Y Z
0 1 2 3 4 5 6 7 8 9
a& Delete
BACK FINISH SELECT
CONFIGURATION
USER MMSI RESET
USER MMSI
COMPLETE!
OK
97