Strobe Led; Emergency Led; Water Hazard Led - Standard Horizon HX890 Owner's Manual

13.7 STROBE LED

Use this selection to set the emergency strobe LED operation.

13.7.1 Emergency LED

Press and hold

key
1. Press the [CH▼]/[CH▲] key to select
"EMERGENCY LED" (default setting), then
press the [SELECT] soft key.
2. Press the [CH▼]/[CH▲] key to select the
desired setting. You can select one from:
"CONTINIOUS" (default setting), "SOS",
"BLINK 1", "BLINK 2", or "BLINK 3".
3. Press the [ENTER] soft key to store the
selected setting.
4. Press the [CLR] key to return to radio operation.

13.7.2 Water Hazard LED

Press and hold

key
1. Press the [CH▼]/[CH▲] key to select
"WATER HAZARD LED", then press the
[SELECT] soft key.
2. Press the [CH▼]/[CH▲] key to select the
desired setting. You can select one from:
"OFF", "ON", or "ON/PWR ON".
OFF:
ON:
ON/PWR ON: The LED lights up and the
3. Press the [ENTER] soft key to store the selected setting.
4. Press the [CLR] key to return to radio operation.
CONFIGURATION

( / key)
CONFIGURATION

( / key)
The LED does not light up.
The LED lights up. (Default
setting)
transceiver turns ON even
if the transceiver is OFF.
SELECT
STROBE LED

(
( key)
CONFIGURATION
STROBE LED
EMERGENCY LED
WATER HAZARD LED
BACK
SELECT
STROBE LED

( key) (
CONFIGURATION
STROBE LED
EMERGENCY LED
WATER HAZARD LED
BACK
SELECT

/ key)
(
CONFIGURATION
EMARGENCY LED
CONTINIUS
SELECT
SOS
BLINK1
BLINK2
BLINK3
BACK
SELECT

/ key) (
CONFIGURATION
WATER HAZARD LED
OFF
SELECT
ON
ON/PWR ON
BACK
key)
ENTER
key)
ENTER
77