Setting Up The Group Call Ringer - Standard Horizon HX890 Owner's Manual

On the display you will notice 3 soft key selections. These
selections are described below:
ACCEPT: Press this key to accept the group call and to
switch to the requested channel.
PAUSE: Press this key to temporarily disable automati-
cally switching to the requested channel.
QUIT: Press this key to stop the automatic channel switch-
ing and revert to the last selected working channel.
5. If you want to respond, monitor the channel to make sure it
is clear, then press the PTT button and talk into the micro-
phone to the group of vessels.
6. Press the [QUIT] soft key to return to radio operation.
Note: If a key is not pressed within 30 seconds the radio
will automatically return to normal radio operation.
When there is an unread group call, the "
display. You may review the unread group call from the DSC log, refer
to the section "10.10.3 Reviewing Other Logged Calls".

10.5.4 Setting up the Group Call Ringer

The HX890 group call ringer may be set to ON or OFF with the DSC SETUP
Menu:
Press and hold

key
1. Press the [CH▼]/[CH▲] key to select
"GROUP", then press the [ENTER] soft key.
2. Press the [CH▼]/[CH▲] key to select "OFF".
3. Press the [ENTER] soft key to store the
selected setting.
4. Press the [CLR] key to return the transceiver to normal operation.
To re-enable the ringer tone, repeat the above procedure, pressing the [CH▼]/
[CH▲] key to select "ON" in step 2 above.
50
DSC SETUP

( / key)
NOTE
" icon will appear on the
SELECT
DSC BEEP

( key) (
INDIVIDUAL
GROUP
ALL SHIPS
POS REQUEST
POS REPORT
BACK
RX GROUP
036690123
CATEG:
CH:
SINCE:
MMSI:
Horizon
ACCEPT
RX GROUP
036690123
CATEG:
CH:
SINCE:

/ key)
DSC SETUP
DSC BEEP
ON
ON
ON
DSC BEEP
ON
ON
SELECT
BACK
Yaesu
ROUTINE
06
00:15
366901234
PAUSE QUIT
Yaesu
ROUTINE
06
00:15
QUIT
SELECT
( key)
GROUP
OFF
ON
ENTER