Noise Cancellation - Standard Horizon HX890 Owner's Manual

4. Repeat step 2 and 3 until the name is complete. The name can consist of
up to 15 characters, if you do not use all 15 characters, select "→" to move
to the next space.
This method can also be used to enter a blank space in the name.
If a mistake was made entering the channel name, press the [CH▼]/[CH▲]/
[◄]/[►] key to select "←" or "→", press the [SELECT] soft key until the
wrong character is selected, then perform steps 2 and 3.
5. Press the [FINISH] soft key to save the name.
6. To enter the name of another channel, repeat the steps 1 through 5.
7. Press the [CLR] key to return to radio operation.
When "CHANNEL NAME" is assigned to a soft key, the channel name
input may be displayed directly by pressing the [NAME] soft key during
radio operation.

14.10 NOISE CANCELLATION

Independently enables/disables the Noise-canceling function of the transmitter
and the receiver.
Press and hold

key
1. Select "TX MODE" with the [CH▼]/[CH▲]
key, then press the [SELECT] soft key.
2. Press the [CH▼]/[CH▲] key to select "ON"
or "OFF", then press the [ENTER] soft key.
3. Select "RX MODE" with the [CH▼]/[CH▲]
key, then press the [SELECT] soft key.
4. Select the noise cancelling level from
"LEVEL 1" through "LEVEL 4" or "OFF"
with the [CH▼]/[CH▲] key, then press the
[ENTER] soft key.
5. Press the [CLR] key to return to radio opera-
tion.
82
CH SETUP

( / key)
NOTE
SELECT
NOISE CANCEL

( key) (
NOISE CANCEL
TX MODE
RX MODE
BACK
BACK

/ key) (
CH SETUP
OFF
OFF
CH SETUP
TX MODE
SELECT
CH SETUP
RX MODE
OFF
BACK
LEVEL1
LEVEL2
LEVEL3
LEVEL4
ENTER
SELECT
key)
OFF
ON
ENTER