Gps Logger Operation - Standard Horizon HX890 Owner's Manual

9.3

GPS LOGGER OPERATION

The HX890 includes a position logger that allows recording the GPS location
information at periodic intervals.
1. Press the [◄]/[►] key repeatedly, then press the [LOGGER]
soft key to turn the function ON or OFF.
The recording starts and the display returns to the previous
screen with the "
• The log interval time of the recording may be changed
via the SETUP menu. Refer to section "16.12 LOGGER
INTERVAL".
Notes:
• The power save operation of the GPS unit is disabled
while the logger is activated.
• To utilize the records, connect the HX890 to a PC and
download the log data from the radio by using the PC
Programming Software. Refer to section "21. CONNECT-
ING A USB DATA TERMINAL TO THE PC".
Logger operation alert:
• When the memory for log data becomes full, three beeps will sound and
a warning message will be displayed. Subsequently, the logger does not
operate until the log data in the memory is erased.
• If the logger cannot record for some reason, three beeps will sound and a
warning message will be displayed. Thereafter, the logger operation ceases.
• When the radio cannot erase the log data in the memory, following a memory-
full alert (see above), an error message will be displayed. (Also, in the SETUP
menu refer to section "16.13 LOG ERASE").
34
" icon at the top of the display.
USA HI
RX
16
P
P-SET
DISTRESS
LAT 33 ° 37.1200
N
LON 118 ° 09.5822
W
TIME LOC 09:56:56
AM
RX USA HI
16
P
P-SET
DISTRESS
LAT 33 ° 37.1200
N
LON 118 ° 09.5822
W
TIME LOC 09:56:56
AM