Table of Contents
Advertisement
ESM-KBLU User's Manual
Flow Control
VT-UTF8 Combo Key
Support
Recorder Mode
Resolution 100x31
Legacy OS Redirection
Resolution
Putty KeyPad
Redirection After BIOS
POST
3.6.2.11.3 Console Redirection Settings
60 ESM-KBLU User's Manual
None[Default]
Hardware RTS/CTS
Disabled
Enabled[Default]
Disabled[Default]
Enabled
Disabled[Default]
Enabled
80x24[Default]
80x25
VT100[Default]
LINUX
XTERMR6
SCO
ESCN
VT400
Always Enable[Default]
BootLoader
Flow control can prevent data loss from buffer
overflow. When sending data, if the receiving
buffers are full, a 'stop' signal can be sent to stop
the data flow. Once the buffers are empty, a
'start' signal can be sent to re-start the flow.
Hardware flow control uses two wires to send
start/stop signals.
Enable VT-UTF8 Combination Key Support for
ANSI/VT100 terminals.
With this mode enabled only text will be sent.
This is to capture Terminal data.
Enables or disables extended terminal resolution.
On Legacy OS, the Number of Rows and
Columns supported redirection.
Select FunctionKey and KeyPad on Putty.
The Settings specify if BootLoader is selected
then Legacy console redirection is disabled
before booting to Legacy OS. Default value is
Always Enable which means Legacy console
Redirection is enabled for Legacy OS.
Advertisement
Table of Contents
