Controlling The Maximum Speed - Invacare LiNX DLX-REM400 User Manual

Invacare® LiNX
The joystick can also be used to wake up the system when
in sleep mode, if this parameter has been enabled by the
provider. Refer to 5.14 The sleep mode, page 53.

5.5.2 Controlling the maximum speed

The speedometer is divided into ten segments, representing
the speed range of the wheelchair. Each segment can be
displayed in one of three colors.
• The green section A displays the speed range,
determined by the set point E on the speed slider D.
• The yellow section B displays the pre-set maximum
speed range C, depending on the programming of the
drive card.
• The grey section F displays that the total maximum
speed range of the wheelchair is not reached in the
depending drive function.
40
In each drive card you are able to control the pre-set
maximum speed depending on your needs.
1.
Swipe-and-tap mode
Slide set point E up
or down, when in
Swipe-and-tap mode.
The proportion of the green sections A and yellow
sections B on the speedometer and the speed slider
correspond to the position of the set point E.
Tap mode
Tap at top or at button
of speed slider D, when
in Tap mode. Plus and
minus symbols indicate
where to tap.
1637423-E