Invacare LiNX DLX-REM400 User Manual page 61

• Speed reduction
If the seat lifter or the seat angle has been adjusted
above a certain point, the drive electronics considerably
reduces the speed of the wheelchair. If speed reduction
has been activated, drive mode can only be used to
carry out movements in reduced speed and not for
regular driving. To drive normally, adjust the lifter or
the seat angle until the speed reduction is deactivated
again.
Speed reduction is shown in the display. If the seat
lifter or the seat angle is raised above a certain
point, the above icon is displayed in the status bar.
This indicator remains active until speed reduction is
deactivated again by lowering the lifter.
1637423-E
Seating function inhibits
• Tilt limit
The maximum tilt limit switch is a function to prevent
the seat tilt or recline from extending beyond a
maximum pre-set angle, when the seat lifter is raised
above a certain point. The drive electronics stops
automatically, a grey exclamation point is displayed
on the seating card and tilting or reclining backwards
is inhibited A.
According to that, an icon with a seat and an
exclamation point is displayed in the status bar. This
indicator remains active until the tilt limit is deactivated
by lowering the lifter.
Fig. 5-33
Usage
61