Advertisement
Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/ANSI, and with all local codes and authorities having jurisdiction.
Product is intended for indoor use only.
1. Remove backplane from enclosure. Do not discard hardware.
2. Mark and predrill holes in the wall to line up with the top three keyholes in the enclosure.
Install two/three upper fasteners and screws in the wall with the screw heads protruding.
Place the enclosure's upper keyholes over the two/three upper screws, level and secure.
Mark the position of the lower two/three holes. Remove the enclosure. Drill the lower holes
and install the two/three fasteners. Place the enclosure's upper keyholes over the two/three
upper screws. Install the two/three lower screws and make sure to tighten all screws.
3. Mount included UL Listed tamper switch(es) (Altronix Model T112 or equivalent) in desired
location, opposite hinge. Slide the tamper switch bracket onto the edge of the enclosure
approximately 2" from the right side (Fig. 1, pg. 3). Connect tamper switch wiring to the
Access Control Panel input or the appropriate UL Listed reporting device.
To activate alarm signal open the door of the enclosure.
TM1 Sub-Assembly Position Chart for the Following Models:
Sub-Assembly
Pem Mounting Current Draw
LNL-2220
LNL-4420
LNL-1100
A
LNL-1200
LNL-1320
LNL-2210
D
LNL-1300e
LNL-1300
E
LNL-3300
G
LNL-8000
Sub-Assembly
Pem Mounting Current Draw
ACM4(CB)
MOM5
PD4UL(CB)
C
PD8UL(CB)
PD16W(CB)
PDS8(CB)
VR6
LINQ2**
F
Sub-Assembly
Pem Mounting Input Rating
AL400ULXB2
AL600ULXB
AL1012ULXB
AL1024ULXB2
B
eFlow4NB**
eFlow6NB**
eFlow102NB**
eFlow104NB**
* For detailed information, refer to the Lenel Hardware Installation Guide, DOC-600 r9.025 October 2018.
** LINQ2 can be installed when utilizing eFlow power supply/charger boards.
- 3 -
Installation Instructions for Trove1, Trove2, Trove3:
12-24VDC 500mA max.
12-24VDC 500mA max.
12-24VDC 350mA max. (12VDC/300mA nom., 24VDC/220mA nom.)
12-24VDC 1100mA max. (12VDC/850mA nom., 24VDC/450mA nom.)
12-24VDC 550mA max. (12VDC/450mA nom., 24VDC/270mA nom.)
12VDC 900mA max.
12VDC 1100mA max.
12-24VDC 150mA max. (12VDC/110mA nom., 24VDC/60mA nom.)
12-24VDC 300mA max.
12VDC 250mA max.
12VDC @ 0.4A max. or 24VDC @ 0.2A max.
12-24VDC @ 55mA max.
N/A
N/A
N/A
N/A
24VDC @ 1.75A or 3.5A (Output: 5VDC or 12VDC @ 6A)
12-24VDC @ 100mA max.
Altronix Power Supplies/Sub-Assemblies
115VAC, 60Hz, 3.5A
115VAC, 60Hz, 3.5A
115VAC, 60Hz, 2.6A
115VAC, 60Hz, 4.2A
120VAC, 60Hz, 3.5A
120VAC, 60Hz, 3.5A
120VAC, 60Hz, 3.5A
120VAC, 60Hz, 4.5A
Lenel Sub-Assemblies*
Altronix Sub-Assemblies
Output Rating
12VDC @ 4A or 24VDC @ 3A
12VDC or 24VDC @ 6A
12VDC @ 10A
24VDC @ 10A
12VDC or 24VDC @ 4A
12VDC or 24VDC @ 6A
12VDC @ 10A
24VDC @ 10A
Tamper
Switch
(provided)
to Access Control
Panel or
UL Listed
Reporting
Device
Refer to
LNL-2220 Quick Reference (QR50L-1002E - revision 2.022)
LNL-4420 Quick Reference
(QR50L-1024E-LNL-4420 - revision 1.001)
LNL-1100 Series 2 Quick Reference
(QR50L-1010E - revision 1.019)
LNL-1200 Series 2 Quick Reference
(QR50L-1009E - revision 1.019)
LNL-1320 Series 2 Quick Reference
(QR50L-1007E - revision 1.020)
LNL-2210 Series 2 Quick Reference
(QR50L-1003E - revision 1.021)
LNL-1300e Quick Reference
(QR50L-1023E - revision 1.000)
LNL-1300 Series 2 Quick Reference
(QR50L-1008E - revision 1.020)
LNL-3300 Quick Reference (QR50L-1001E - revision 2.023)
LNL-8000 Quick Reference (QR50L-1000E - revision 1.020)
Refer to
ACM4/ACM4CB Installation Instructions Rev. 051311
MOM5 Installation Instructions Rev. 042811
PD4UL Installation Instructions IIPD4UL Rev. 051311
PD4ULCB Installation Instructions IIPD4ULCB Rev. 051311
PD8UL Installation Instructions IIPD8UL Rev. 051311
PD8ULCB Installation Instructions IIPD8ULCB Rev. 051311
PD16W/PD16WCB Installation Instructions
IIPD16W Rev. 051311
PDS8/PDS8CB Installation Instructions Rev. 070116
VR6 Installation Instructions Rev. 050517
LINQ2 Installation Instructions Rev. 060514
Refer to
ULXB Installation Instructions Rev. ULXB-10182016
ULXB Installation Instructions Rev. ULXB-10182016
ULXB Installation Instructions Rev. ULXB-10182016
ULXB Installation Instructions Rev. ULXB-10182016
eFlow Installation Instructions Rev. EFNB-10182016
eFlow Installation Instructions Rev. EFNB-10182016
eFlow Installation Instructions Rev. EFNB-10182016
eFlow Installation Instructions Rev. EFNB-10182016
Fig. 1
Edge of
Enclosure
Enclosure
Trove / Lenel
Advertisement
