Altronix Trove Series Installation Manual

Access & Power Integration
Trove2KA2
- Trove2 enclosure with
Altronix/Keyscan backplane (TKA2)
Installation Guide
Trove2KA2 accommodates various combinations of Keyscan boards with or without Altronix power supplies and accessories for
access systems.
Trove2KA2
- Trove2 enclosure with TKA2 Altronix/Keyscan backplane.
• Includes: tamper switch, cam lock, lock nuts and
mounting hardware.
• 16 Gauge grey enclosure with ample knockouts for
convenient access.
Enclosure Dimensions (H x W x D):
27.25" x 21.75" x 6.5" (692.2mm x 552.5mm x 165.1mm).
• Two (2) AL400ULXB2, AL600ULXB, AL1012ULXB, AL1024ULXB2, eFlow4NB, eFlow6NB, eFlow102NB, or eFlow104NB.
• One (1) T16100, ACM4(CB), ACM8(CB), MOM5, PD4UL(CB), PD8UL(CB), PDS8(CB), VR6.
• One (1) CA250B, CA4500B, CA8500B, one (1) DPS-15, one (1) CIM and two (2) OCB8.
1. Remove backplane from enclosure prior to mounting (do not discard hardware).
2. Mark and predrill holes in the wall to line up with the top keyholes in the enclosure. Install the upper fasteners and screws in the wall
with the screw heads protruding. Place the enclosure's upper keyholes over the screws; level and secure. Mark the position of the
lower holes. Remove the enclosure. Drill the lower holes and install the fasteners. Place the enclosure's upper keyholes over the
upper screws. Install the lower screws and make sure to tighten all screws (Enclosure Dimensions, pg. 4).
3. Mount included UL Listed tamper switch (Honeywell Model 112 or equivalent) in desired location, opposite hinge.
Slide the tamper switch bracket onto the edge of the enclosure approximately 2" from the right side (Fig. 1, pg. 1).
Connect tamper switch wiring to the Access Control Panel input or the appropriate UL Listed reporting device.
To activate alarm signal open the door of the enclosure.
4. Mount Altronix/Keyscan boards to backplane, refer to Page 2.

Hardware:

Snap On Standoff |
5/16" Pan Head Screw |
All registered trademarks are property of their respective owners.
Backplane Accommodates a Combination of the Following:

Installation Instructions for Trove2:

Metal Standoff
Lock Nut
TKA2
- Altronix/Keyscan backplane only

Overview:

Specifications:

TKA2
- TKA2 Altronix/Keyscan backplane.
• 16 Gauge backplane.
• Includes mounting hardware.
Dimensions (H x W x D):
25.375" x 19.375" x 0.3125" (644.6mm x 492.1mm x 7.9mm).
TKA2_Rev. 042816
Honeywell
model # 112
Tamper Switch
or equivalent
(provided)
Enclosure
Edge of
Enclosure
to Access Control Panel
or U.L. Listed
Reporting Device
Fig. 1