Advertisement
Installation Instructions for Altronix Power Supplies and/or Sub-Assemblies to TM3:
1. Fasten standoffs (provided) to pems that match the hole pattern for Altronix Power Supply/Chargers or Altronix Sub-Assembly boards (Fig. 7, pg. 11).
Use snap on nylon standoffs for the upper two mounting holes in the board.
Use metal standoffs for the bottom mounting holes to provide sufficient grounding for the board.
2. Affix boards to standoffs (Fig. 7a, pg. 11) by pressing down the upper mounting holes onto nylon standoffs.
Use provided mounting screws to affix the lower mounting holes. Make sure that boards are locked onto standoffs.
3. For detailed information about installing and connecting Altronix sub-assemblies refer to the individual Installation Instructions listed in the
Sub-Assembly Position Chart, pg. 10 and Trove Installation Guide, Rev. 101817.
4. Fasten backplane to Trove3 enclosure utilizing lock nuts (provided).
Fig. 7
C
Metal Standoff Placement
Metal Standoff Placement
B
B
B
B
Trove / Lenel
A
A
A
A
Fig. 7a
Pem
Snap on or
Metal
Standoff
Backplane
Sub-Assembly
- 11 -
Advertisement
