Fluke CertiFiber Pro User Manual page 59

Setting
Module
Test Type
Bi-Directional
Fiber Type
Fiber Type
Settings
Test Limit
Table 2. Settings for Fiber Tests
Select the CertiFiber Pro module you will use.
Use Smart Remote mode for tests on duplex-fiber
cabling. See page 55.
Use Loopback mode for tests on patch cords and cable
spools. See page 64.
Use Far End Source mode for tests on individual fibers.
See page 72.
Off: The tester does fiber tests in only one direction.
On: The tester does fiber tests in both directions. See "Bi-
Directional Tests" on page 80.
The Bi-Directional setting is not available for Far End
Source mode.
Select a fiber type that is correct for the type you will
test. To see a different group of fiber types, tap MORE,
then tap a group. To make a custom fiber type, tap
Custom in the Fiber Groups list. See the Technical
Reference Handbook.
IOR: The tester uses the index of refraction to calculate
the optical length of the fiber. Each fiber type includes
the value specified by the manufacturer. To use a
different IOR, make a custom fiber type. See the
Technical Reference Handbook.
Select the correct test limit for the job. To see a different
group of limits, tap MORE, then tap the name of a
group. To make a custom limit, tap Custom in the Limit
Groups list. See the Technical Reference Handbook.
Chapter 3: How to Certify Fiber Cabling
Description
Settings for Fiber Tests
-continued-
49