Fluke CertiFiber Pro User Manual page 94

CertiFiber Pro Fiber Optical Loss Test Set
Users Manual
To do the FiberInspector test
1 Connect the probe to the type A USB port on the side of the
tester.
2 Make sure the correct tip is on the probe.
3 Clean the connector that you will inspect.
4 Do the FiberInspector test:
To do the FiberInspector test when it is in the project
a. On the home screen, tap the test setup panel.
b. On the CHANGE TEST screen, tap the FiberInspector test,
then tap USE SELECTED.
c. Tap Test or press .
To do the FiberInspector test when it is not in a project
On the home screen, tap the TOOLS icon, then tap
FiberInspector.
84