A
B
C
Figure 33. Light Source Controls for the Main Tester
Use the buttons to control the output port when you use the
main tester as a light source:
Auto: In this mode, the output port transmits both
wavelengths. The signal includes identifiers that tell a
CertiFiber Pro or SimpliFiber Pro power meter when to
measure power at each wavelength. Use this mode only
with a CertiFiber Pro or SimpliFiber Pro power meter.
Off: The output port does not transmit the selected
wavelength.
CW: The output port transmits a continuous signal at one
wavelength. Use this mode if the power meter is not a
CertiFiber Pro or SimpliFiber Pro meter.
The laser icon is red when the output port transmits the
wavelength adjacent to the icon.
When the tester has a CertiFiber Pro Quad module installed, use
this control to select multimode or singlemode wavelengths
Chapter 6: The Power Meter and Light Source
How to Control the Light Source
GPU127.EPS
99