Fluke CertiFiber Pro User Manual page 18

CertiFiber Pro Fiber Optical Loss Test Set
Users Manual
If this equipment is used in a manner not specified

by the manufacturer, the protection provided by the
equipment can possibly be impaired.

Warning: Class 1 and Class 2 Laser Products
To prevent possible eye damage caused by
hazardous radiation:
Do not look directly into optical connectors. Some

optical equipment emits invisible radiation that can
cause permanent damage to your eyes.
Keep the module's OUTPUT ports covered with a

dust cap or keep a test reference cord attached. The
OUTPUT ports can emit radiation even when you do
not do a test.
Do not run any tests that activate the outputs on

the tester unless a fiber is attached to the output.
When you inspect fiber endfaces, use only

magnification devices that have the correct filters.
Use of controls, adjustments, or procedures not

stated herein can possibly result in hazardous
radiation exposure.
To prevent damage to the tester or cables under
test and to prevent data loss:
Do not connect the tester to an active network.

Doing so causes unreliable test results, can disrupt
network operations, and can cause damage to the
module's receiver.
 Use proper cleaning procedures to clean all fiber
connectors before every use. Neglecting this step or
using improper procedures can cause unreliable test
results and may permanently damage the
connectors. See Chapter 6.
8

Caution
