Table of Contents
Advertisement
binding
12 / 32
To establish a connection with the transmitter, the Graupner HoTT
receiver must first be "bound" to at least one model memory in "its"
Graupner HoTT transmitter. This process is generally called "bind-
ing". However, the available methods to be used are not always the
same, so the following step-by-step instructions apply only to bind-
ing a HoTT AIO FC to any transmitter:
Binding step-by-step
• If the AIO FC is already bound to a specific transmitter and this
binding should be maintained, the transmitter should ideally be
switched on before the receiver. At the latest, however, within
approximately 15 seconds from the moment when the receiver
is switched on, the red LED of the receiver is constantly on.
Attention
As soon as the LED starts to flash, the AIO FC is in bind mode.
From this point on there is the risk that the AIO FC unintention-
ally binds to a transmitter, which is casually in bind mode at the
same time, whereupon the model can run uncontrolled at any
time. The distance between transmitter and AIO FC should be at
least 0.5 m, otherwise the receiver of the AIO FC can be over-
driven.
• If the AIO FC is unbound or it should be bound to another trans-
mitter or only the model memory has to be changed than the
previous one, proceed as follows:
1. Prepare the transmitter or model memory to be bound accord-
ing to the instructions for binding.
2. Switch on the copter power supply.
3. The LED of the AIO FC lights constantly red.
4. Approximately 15 seconds after the AIO FC is switched on, its
red LED starts to flash, indicating that the AIO FC is now in
bind mode.
5. Start the transmitter-side binding according to the instruc-
tions of the transmitter.
6. If the red LED of the AIO FC goes out within about three sec-
onds, the binding process has been completed successfully.
7. Your transmitter/AIO FC combination is ready for operation.
8. If the LED on the AIO FC remains still red, the "binding" has
failed. Change the positions of the associated antennas and
try the entire procedure again.
S1035_Falcon_12_Q06_V1sh
Advertisement
Table of Contents
