Binding - GRAUPNER HoTT mz-8P Manual

binding

S1032_mz-8P_V1.1sh
Rx volt / temp Blinks quickly
Out of range Blinks slowly
System error
Normal Trim inc/dec
mode
Trim 0%
Program Program mode start Blinks 1x
mode
Program mode end
Servo reverse (normal)
Servo reverse (reverse)
ATV 100%
Fail Safe mode start Blinks 2x
Fail Safe „HOLD"
Fail Safe „POS"
Stick cali- Calibration mode start Blinks 1x 3x
bration
Calibration ended Blinks 3x 3x
„Deadband" setting
Flip mode 360° FLIP active
Motor Motor cut OFF
OFF
Camera Snapshot
Video record
If no copter is still bound to the transmitter or if another copter is to
be bound to the transmitter, proceed as follows:
Binding step-by-step
1. Switch on transmitter.
The red status LED of the transmitter flashes once per second.
2. Start the copter by plugging in the drive battery or switching on
the power supply.
3. Possibly put the copter in bind mode according to its instructions.
4. Press the LED button on the bottom left of the transmitter.
If the binding process was successful, the red status LED of the
transmitter lights up constantly. Otherwise the process has to be
repeated.
Notes
• After a binding process, the highest control sensitivity is always
preset by default. If you press the "SPEED" button, you can
reduce it to "medium" (2-way sound) or "low" (1-way sound).
Blinks 1x 5x
Blinks 2x 5x
Blinks 1x 5x
Blinks 2x 5x
Blinks 3x 3x
Blinks / 3sec
Blinks
quickly
ON/OFF
Blinks slowly
2x high / 2sec
1x high / 2sec
1x low / 2sec
1x low / click
1x high / click
1x low
1x low
1x low
2x low
1x high
2x low
1x low
1x high
2x low
10x high / 2 sec
3x low
ON: 1x low / OFF: 2x high
13 / 24