GRAUPNER S1038 Manual page 14

Aio copter flight control
Hide thumbs Also See for S1038:
Table of Contents

Advertisement

E5
3
+100% +100%
E6
SW6/7
+100%
+125%
+100% +100%
E7
free
E8
free
+100% +100%
Trvl
0 %
1
2
0 %
+100 %
3
0 %
4
5
+100 %
6
0 %
+
0 %
0 %
7
8
SW4/5
E5
+100% +100%
E6
SW6/7
+100%
+100%
3
+100% +100%
E7
E8
free
+100% +100%
Trvl
0 %
1
2
0 %
+100 %
3
0 %
4
5
+100 %
6
0 %
+
0 %
0 %
7
8
SW4/5
E5
+100% +100%
E6
SW6/7
+100%
+100%
3
+100% +100%
E7
E8
free
+100% +100%
Trvl
0 %
1
2
0 %
+100 %
3
0 %
4
5
+100 %
6
0 %
+
0 %
0 %
7
8
14 / 32
Only S1038:
C5 = 0% (Attitude mode) and C6 = 125% = Auto-flip mode
C5 = 0% (Attitude mode) and C6 = 100% = switching between the
FPV transmitter channels, only when the motors are switched off.
+
Only S1039 and only with GPS 33602: Autopilot mode
C5 = -100% and C6 = 0% = Autopilot mode (with GPS), control of the
copter speed. Neutral stick position means GPS position and altitude
hold.
If you start in autopilot mode, the height is maintained at the middle
of the stick (0%).
If you start in Rate or Attitude mode and then switch to the autopi-
lot mode, the throttle position when switching the mode is the stick
position at which the altitude is maintained.
+
C5 = -100% and C6 = -100% = Come back home to the start point
(with GPS)
C5 = -100% and C6 = +100% = Departure from previously pro-
grammed waypoints (in preparation)
Note
When the GPS is connected, the copter only allows the motors to be
switched on if 6 GPS satellites or more are found.
While searching for GPS satellites, an HD camera should be off. If
more than 8 satellites have been found, the HD camera can be
switched on. Check if there are more than 6 satellites in the GPS Cop-
ter telemetry display. The Autopilot and Come back home mode only
work in the configuration of how the compass was calibrated (eg
with HD camera on. If you change the airfield, the compass should
be recalibrated.
Only S1039: Carefree GPS mode
C5 = -100% and C6 = 0%, so as C7 = +100% = Carefree control mode
In Carefree control mode, the flight direction is saved when acti-
vated, even if the Copter is then rotated by yaw command.
This facilitates the control of the copter in difficult visibility condi-
+
tions.
C5 = -100% and C6 = 0%, so as C7 -100%....+50% = normal control
mode
S1035_Falcon_12_Q06_V1sh

Advertisement

Table of Contents
loading

This manual is also suitable for:

S1039

Table of Contents