Axis Assignment - GRAUPNER S1038 Manual

AXIS ASSIGNMENT

!
AXIS ASSIGNMENT
NEW SETUP
ROLL
NICK
YAW
26 / 32
Only by S1039: LOGGING
Logging 0 displays the Euler angles in the Copter telemetry display
and also allows the position display using the Graupner HoTT OSD #
33641 on the FPV screen or in the FPV video goggles.
The other logging functions are exclusively intended for the service.
Note
The gyroscope calibration, required each time the copter is switched
on, takes place as soon as the copter or its receiver is absolutely
quiet. The motors will not start until the calibration is completed.
After approx. 3 seconds in the rest position, several beeps can be
heard from all motors. The number of beeps varies depending on
the speed controller used. These "wiggles" signal that initialisation
has been successful and that calibration is complete.
CAUTION
If the copter is used for long time (>1min) in Acro 3D mode the
receiver can loose its position information and the copter can
move itself out of control. In this case the copter should be left in
the rate mode and hover or land calmly for approx. 30 s, so that
the receiver can track the position again.
In this display, the gyros and their effective direction are to be deter-
mined.
NO
+0
NEW SETUP
+0
+0
After selecting the line "do setup" and changing the value field to
"yes", assign the axes as follows:
Do setup step by step
1. Push or tap on the ENT key
"NO" is displayed inverted.
2. Change the value field to "YES".
3. Push or tap on the ENT key
4. At the transmitter briefly bring the roll control stick to the right
stop.
The display shows the roll axis inverted.
5. Tilt the copter more than 45 degrees to the right.
As soon as the detected axis with the required sign is displayed in
"normal" representation, the axis assignation is completed.
S1035_Falcon_12_Q06_V1sh