Installing The Power Supply And Cord - Paradyne FrameSaver SLV 9x24 Series Installation Instructions Manual

Installing the Power Supply and Cord

1. Insert the 4-prong plug into the POWER jack.
When inserting the plug at the rear of the FrameSaver unit, align the plug with the
notch above the POWER jack. Make sure the locking tab snaps securely into the
jack.
Locking
Tab
POWER
(FrameSaver 9124
Shown)
Verification Check:
Did any LEDs light?
H
If yes, the FrameSaver unit has power and is operational.
H
If no, refer to Troubleshooting Power and COM Port Connections on page 6.
COM DSX-1 NETWORK
4
2. Insert the 3-prong plug
into an ac outlet.
3-Prong
Grounded
AC Outlet
Power Cord /
Transformer
3.
The front panel
OK LED lights.
98-15823