Setting Up For Management - Paradyne FrameSaver SLV 9x24 Series Installation Instructions Manual

Setting Up for Management

See Configuring the Communication Protocol and Configuring SNMP Management
in Chapter 9, Configuration Options , of the User's Guide to read about the configuration
options identified in the following procedure.
To set up SNMP management:
1. Select Communication Protocol configuration options.
Configuration Edit/Display
Communication Protocol
2. Minimally, enter the following options:
– Node IP Address
– Node Subnet Mask
3. Press Esc once to return to the Management and Communication menu.
4. Select General SNMP Management and press Enter.
5. Minimally, set Name 1 Access to Read/Write.
6. Press Ctrl-a to move the cursor to the bottom of the screen, type s (Save), and
press Enter. The Save Configuration To: prompt appears.
7. Select Current Configuration and press Enter.
8. Press Esc three times to return to the Main Menu.
Proceed to Setting Up Auto-Configuration on page 11.
Management and Communication
10