Setting Up Auto-Configuration - Paradyne FrameSaver SLV 9x24 Series Installation Instructions Manual

Setting Up Auto-Configuration

The default frame relay discovery mode is 1MPort. If you do not want management
links configured or auto-configuration, change the default setting for FR Discovery. The
following table describes the difference between the various settings.
FR Discovery Mode
1MPort
(Default)
1Port
NetOnly
Disable
See Using Auto-Configuration in Chapter 3, Typical Applications , and Setting Up
Automatic Configuration in Chapter 8, Setup , of the User's Guide for more information.
To change the default setting for FR Discovery:
1. Select Auto-Configuration.
Main Menu Auto-Configuration
2. Select another frame relay discovery mode (FR Discovery).
3. Press Ctrl-a to move the cursor to the bottom of the screen.
4. Type s (Save) and press Enter. The Delete All DLCIs and PVC Connections?
prompt will appear. Type y ( Yes) and press Enter.
5. Press Esc three times to return to the Main Menu.
Description
Auto-configuration is enabled, and for each DLCI
discovered on the network, a multiplexed network DLCI
and a standard port DLCI will be configured and
connected. The multiplexed network DLCI will contain
one EDLCI for management traffic, and one EDLCI for
customer data. The customer data EDLCI on the network
will be cross-connected to the data port DLCI.
Auto-configuration is enabled. For each DLCI discovered
on the network, a multiplexed network DLCI and a
standard port DLCI will be configured and connected,
creating a PVC within the FrameSaver unit. No
management DLCIs will be configured on the network
interface.
Auto-configuration is enabled, DLCIs are discovered on
the network interface, but no cross-connections are
configured.
No frame relay discovery takes place. No DLCIs will be
configured on the network interface. The user must
manually configure the FrameSaver unit.
11