Setting Up Service Provider Connectivity - Paradyne FrameSaver SLV 9x24 Series Installation Instructions Manual

Setting Up Service Provider Connectivity

If management needs to be set up between a service provider's customer and its
network operations center (NOC), a non-multiplexed DLCI must be configured to carry
management data between the customer's central site and the NOC console. This
requires that a frame relay discovered DLCI needs to be modified. This is because all
frame relay discovered network DLCIs are configured as multiplexed.
To set up NOC management:
1. Select DLCI Records on the network interface:
Configuration Edit/Display
2. Type o (Modify) and press Enter. The Modify DLCI Record for DLCI Number?
prompt will appear.
2. Select the DLCI that will be used
number appears, then press Enter.
3. With the cursor on the DLCI Type field, press the spacebar to change the DLCI
Type from Multiplexed to Standard.
The Delete EDLCI Connections and Make it a Mgmt Only PVC? prompt appears.
4. Type y for yes and press Enter.
PVC connections for the selected DLCI are broken, the Port-1 DLCI mapped to this
network DLCI and the embedded management DLCI (EDLCI) are deleted, and the
selected DLCI will be reconfigured as a management PVC.
Network DLCI Records
by
pressing the spacebar until the correct DLCI
15