Paradyne FrameSaver SLV 9x24 Series Installation Instructions Manual page 26

Your telephone company may make changes in facilities, equipment, operations, or
procedures that could affect the proper operation of your equipment. If so, you will be
given advance notice so as to give you an opportunity to maintain uninterrupted
service.
No repairs may be performed by the user. Should you experience difficulty with this
equipment, refer to the Warranty, Sales, and Service Information section on page 27.
For FrameSaver 9124 units, make the T1 network connection using a Universal
Service Order Code (USOC) type RJ48C jack for single-line installations and type
RJ48H jack for multiline installations. Specify both the Service Order Code 6.0F, as well
as the proper Facility Interface Code, to the telephone company when ordering the T1
line. The T1 equipment can be configured to support any of the framing format and line
signaling techniques shown in the table below. The T1 equipment's configuration must
correspond to the T1 line's parameters.
Facility Interface Codes
Code
04DU9-BN
04DU9-DN
04DU9-1KN
04DU-1SN
After the telephone company has installed the requested services and jacks, you can
connect the access unit with the cable provided. An FCC-compliant telephone cord and
modular plug are provided with this equipment. This equipment is designed to be
connected to the telephone network or premises wiring using a compatible modular
jack that is Part 68 compliant.
Canada
Notice to Users of the Canadian Telephone Network
The Industry Canada label identifies certified equipment. This certification means that
the equipment meets telecommunications network protective, operational and safety
requirements as prescribed in the appropriate Terminal Equipment Technical
Requirements document(s). The Department does not guarantee the equipment will
operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. The equipment
must also be installed using an acceptable method of connection. The customer should
be aware that compliance with the above conditions may not prevent degradation of
service in some situations.
Description
1.544 Mbps superframe format (SF) without line
power
1.544 Mbps SF and B8ZS without line power
1.544 Mbps ANSI ESF without line power
1.544 Mbps ANSI ESF and B8ZS without line power
26