Connecting To The Network - Paradyne FrameSaver SLV 9x24 Series Installation Instructions Manual

Connecting to the Network

1. Insert the 8-pin connector of the network cable into the network interface.
– If a FrameSaver 9124 or NNI, it is a RJ48C (T1) network cable.
– If a FrameSaver 9624, it is a RJ48S (DDS) network cable.
2. Insert the other end of the cable into the RJ48C (T1) or RJ48S (DDS) modular jack.
POWER
COM
NOTE:
After connecting the network cable, wait a few minutes to allow
Auto-Configuration a chance to discover DLCIs.
Proceed to page 13 to verify the network connection.
RJ48C - FrameSaver 9124
RJ48S - FrameSaver 9624
NETWORK
DSX-1
(FrameSaver 9124
Shown)
12
Jack
98-15826