Check That Data Is Being Received; Check Pvc Connections - Paradyne FrameSaver SLV 9x24 Series Installation Instructions Manual

Check that Data is Being Received

1. Press Esc until you return to the Main Menu.
2. Select Performance Statistics, and select an interface's frame relay statistics
(e.g., Network Frame Relay).
Main Menu Status
3. Verify that the Frames Received and Characters Received counts under the
Frame Relay Link statistics are incrementing, and there are no errors under the
Frame Relay LMI statistics.
– If data is being received, the FrameSaver unit is receiving data. If count
increments occur after refreshing the screen, the unit is receiving data.
– If data is not being received, recheck the cable connections, and replace or repair
a damaged cable. Recheck LMI status; you may need to contact your service
provider. Next, check the DLCI's status.
Helpful Hint:
Type r for Refresh and press Enter to update the counts that are displayed.
See Chapter 11, Displaying System Information , of the User's Guide for additional
status information. See Chapter 13, Troubleshooting , for additional troubleshooting
information.

Check PVC Connections

Check PVC connections to verify that all PVCs, including management PVCs, are
configured, and to see whether the PVC is active or not.
1. Press Esc to return to the Status menu.
2. Select PVC Connection Status.
The PVC Connection Status screen shows all PVC connections; the interface
source and DLCI number of the incoming data linked to the interface and DLCI
number for the outgoing data. You can also see whether the PVC is active.
3. Verify that each PVC is active.
– If active, the FrameSaver unit should be passing data.
– If not active, no data traffic can be carried by the PVC. If the PVC is configured
correctly, the circuit may be down.
See Chapter 11, Displaying System Information , of the User's Guide for additional
status information. See Chapter 13, Troubleshooting , for additional troubleshooting
information.
Performance Statistics
20
Network Frame Relay