Connecting To The Network - Paradyne FrameSaver SLV Series Installation Instructions Manual

To change the default setting for Frame Relay (FR) Discovery:
1. Select Auto-Configuration.
Main Menu
2. Select another frame relay discovery mode.
3. Save the change. The Delete All DLCIs and PVC Connections? prompt will
appear.
4. Make your selection, Yes or No.
5. Return to the Main Menu.
NOTE:
If auto-configuration creates a multiplexed DLCI, but a standard DLCI is
needed, change the DLCI to standard from the network DLCI Records screen:
Configuration

Connecting to the Network

1. Insert the 8-pin connector of the network cable into the network interface.
– If a FrameSaver 9124, 9126, or 9128, it is a RJ48C (T1) network cable.
– If a FrameSaver 9624, it is a RJ48S (DDS) network cable.
2. Insert the other end of the cable into the RJ48C (T1) or RJ48S (DDS) modular
jack.
POWER
NOTE:
After connecting the network cable, wait a few minutes to allow
Auto-Configuration a chance to discover the frame relay characteristics and
DLCIs.
Proceed to page 18 to verify the network connection.
Auto-Configuration
Network
COM
(FrameSaver 9124
Shown)
DLCI Records
DSX-1 NETWORK
17
RJ48C or
RJ48S
Jack
98-15826-01