Dhw Connection And Safety Assembly - STIEBEL ELTRON HSBC 200 Operation And Installation

INSTALLATIoN
Installation
11.2.3 Connection
Installation example:
2
1 Pipes carrying heating water
2 Pressure hose (available as accessory)
f Thoroughly flush the pipes before connecting the heat pump. f
Foreign bodies (e.g. welding pearls, rust, sand, sealant, etc.)
can impair the operational reliability of the heat pump.
f Install the heating water pipes (see chapter "Specification / f
Dimensions and connections").
Safety valve
1 Drain hose
2 Fasteners (not part of the standard delivery)
3 Drain (not part of the standard delivery)
f Size the drain hose so that water can drain off unimpeded f
when the safety valve is fully opened.
f Ensure that the safety valve drain hose is open to the outside. f
f Lay the safety valve drain hose with a constant fall to the f
drain.
f Secure the drain hose to prevent any hose movement while f
water is discharged.
www.stiebel-eltron.com

11.3 DHW connection and safety assembly

11.3.1 Safety instructions
1
!
!
Cold water line
Galvanised steel, stainless steel, copper and plastic are approved
materials.
!
DHW line, DHW circulation line
Stainless steel, copper and plastic are approved materials.
11.3.2 Installing the DHW circulation line, if applicable
A DHW circulation line with external DHW circulation pump can be
fitted to the DHW circulation connection (see chapter "Specification
/ Dimensions and connections").
f Remove the sealing cap from the DHW circulation connection f
(see chapter "Specification / Dimensions and connections").
f Connect the DHW circulation line. f
1
2
3
f Open the shut-off valve for the DHW circulation. f
Material losses
The maximum permissible pressure must not be exceed-
ed (see chapter "Specification / Data table").
Material losses
Operate the appliance only with pressure-tested taps.
Material losses
A safety valve is required.
HSBC | 39