OPERATION General information OPERATION Symbol Meaning Material losses (appliance damage, consequential losses and environmen- tal pollution) Appliance disposal General information The chapters "Special Information" and "Operation" are intended f This symbol indicates that you have to do something. The ac- for both the user and qualified contractors.
OPERATION Appliance description Material losses Never subject the appliance to water pressure. The tap outlet has a vent function. Scale build-up can block the outlet and subject the appliance to pressure. f Never seal the tap outlet. f Only use special aerators for non-pressurised water heaters.
INSTALLATION Safety INSTALLATION Preparations f Flush the water line thoroughly. Water installation Safety A safety valve is not required. Only a qualified contractor should carry out installation, commis- Taps sioning, maintenance and repair of the appliance. Sealed taps are not permitted. General safety instructions f Install an open tap.
Page 5
Observe the type plate. accordance with regulations. The following electrical connections are permissible: Material losses Counterhold with a suitable spanner when tightening the SNU 5 SL 1 kW SNU 5 SLi fittings. Connection to a freely accessible standard socket Permanent connection to an ap-...
Page 6
INSTALLATION Commissioning 10. Commissioning 11. Settings 11.1 Setting the temperature limit WARNING Electrocution Commissioning may only be carried out by a qualified contractor in accordance with safety regulations. 10.1 Initial start-up f Either open the DHW valve of the tap or set the mono lever 1 Temperature selector mixer tap to "hot"...
INSTALLATION Maintenance 14. Maintenance 14.4 Cleaning the strainer WARNING Electrocution Before any work on the appliance, disconnect all poles of the appliance from the power supply. f Dismount the appliance for maintenance work. 14.1 Draining the appliance WARNING Burns Hot water may escape during the draining process. f Drain the appliance via the connector.
The test symbols can be seen on the type plate. 15.5 Extreme operating and fault conditions In the case of faults, a peak temperature up to 100 °C may briefly occur in the system. SNU 5 SL 1 kW SNU 5 SLi Cold water Inlet Male thread...
Page 9
INSTALLATION Specification 15.6 Data table SNU 5 SL 1 kW SNU 5 SLi SNU 5 SLi 221116 221121 229467 Hydraulic data Nominal capacity Mixed water volume 40 °C Electrical data Rated voltage Rated output Rated current Fuse/MCB rating Phases 1/N/PE...
GUARANTEE | ENVIRONMENT AND RECYCLING Guarantee The warranty conditions of our German companies do not apply to appliances acquired outside of Germany. In countries where our subsidiaries sell our products, it is increasingly the case that warranties can only be issued by those subsidiaries. Such warranties are only granted if the subsidiary has issued its own terms of warranty.
Page 13
Who gives the warranty 1. The warranty is given by Stiebel Eltron (Aust) Pty Ltd (A.B.N. 9.3. The name, address and contact details (such as 82 066 271 083) of 6 Prohasky Street, Port Melbourne, Victoria, phone number and e-mail address) of the owner;...
Page 14
(h) accidental damage; 19. The Stiebel Eltron warranty for the unit is in addition to (i) act of God, including damage by flood, any rights and remedies you may have under the Australian storm, fire, lightning strike and the like;...